eBay Classifieds » All ads » 

Electronics in Ocala

(1-19 of 19 ads)
View as:
0 results found in Cell phones category, but there are 19 results in Electronics category
Categories
Price [clear]
$ to
    Ads
    1. Pioneer PL-L1000 & Phase Linear 8000 suspension stanchion kit

      Hello, Now available is a custom aluminum drop-in replacement for the Pioneer PL-L1000, PL-L1000A, PL-L5, Phase Linear 8000 Series II, and Phase Linear 8000A suspension stanchion/upper spring seat assembly. Although the Pioneer and Phase Linear service manuals never refer to this assembly as a stanchion, I refer to it here as such for simplicity and because it should have been called that ...

    2. Pioneer PL-L1000 suspension spring seats. Also fits other models.

      Hello, This listing's text must be read in its ENTIRETY. Not doing so will result in your dissatisfaction and mine. This kit is a replacement for Pioneer's coaxial suspension spring boot/seat (or "Rubber Cushion" in Pioneer's terminology). The pictures in this listing show my replacement seats, a typical disintegrated boot/seat, and a very rare still intact boot/seat. It consists of four ...

    3. Pioneer PL-L1000 and PL-L1000A custom supplemental plinth upgrade.

      Hello, This listing is for a custom made turntable supplemental plinth kit. It is designed for the Pioneer PL-L1000, PL-L1000A, and PL-L5. It also fits the Phase Linear 8000 Series II and the 8000A turntables. Although the top plinth of this turntable series is made from respectable ribbed 2.5mm (nominal) thick cast aluminum, it is NOT the active chassis to which the main motor and tonearm ...

    4. Linn Sondek LP12 high-end belt drive turntable

      Hello, Listed is a Linn Sondek LP12 belt drive turntable. I just re-caped the Valhalla power supply with new Nichicon electrolytic capacitors and calibrated the motor drive voltage via RV1 to 80VAC. The motor winding resistance on both coils was checked and determined to be about 4.09kohms each. The motor was checked for noise and its bearings have been lubed with the correct synthetic ...

    5. 2000/4000 power 12/120 volt inverter

      this is a new in the box 2000/4000 power inverter hook it to a 12volt battery such as your car battery or other source you have 120 volt when camping or power outages these inverer are very dependable last for years ihave 1000/2000 pure seine, 5000/10000, 2000/4000, i have a 600 watt pure seine for 160.00 all new inverters email me let me know what you need i have some solar supplies left ...

    6. infocus director control

      new in focus director control..used w/ home theaters...$25 ..352-596-3348

    7. MOBILE HOME CIRCUIT BREAKERS

      fOR SALE ARE MANY OLDER MOBILE HOME CIRCUIT BREAKERS, THESE ARE THE OLDER FLORIDA PACIFIC BRAND, HARD TO FIND AND SEVERAL DIFFERENT SIZES, LET ME KNOW WHAT YOU NEED, PRICES START AT 10.00 ea. prices start at 10.00 each. Thanks Richard

    8. Kyocera Toner A Cartridge For Sale (Make Offer)

      I am selling a genuine Kyocera Toner A Cartridge. It fits the following Kyocera printers (KM-2530 / 3530 / 4030, KM-3035 / 4035 / 5035). The cartridge is brand new in a box. The box was only opened to take pictures. The item # is 370AB04. If you have any questions feel free to contact us by phone at: 352-797-9007 or by email

    9. Pioneer PL-L1000 & Phase Linear 8000 tonearm counterweight upgrade

      Hello, This replacement rigid tonearm counterweight kit will fit Pioneer PL-L1000, PL-L5, and Phase Linear 8000 Series II turntables. It will also fit Pioneer PL-L1000A and Phase Linear 8000A turntables, but please read the post script note below. It features an attractive black wrinkle finish. The removal of the original decoupled counterweight and installation of my rigid design takes ...

    10. Yamaha PX-2 & PX-3 tonearm counterweight upgrade

      Hello, This replacement rigid tonearm counterweight kit will fit Yamaha PX-2 and PX-3 turntables utilizing both YA-27 and YA-32 tonearms. It features an attractive black wrinkle finish. The removal of the original decoupled counterweight and installation of my rigid design takes approximately 40 minutes and includes clear instructions. This kit comes with two different mass counterweights ...

    11. Tonearm damper for linear tracking turntables

      Hello, I am very proud to introduce an exciting new product of my design that addresses two of the more important areas of turntable performance. If you have been around high-end turntables for any length of time you are undoubtedly aware of how spirited the cartridge-tonearm fundamental resonance and overall cartridge-tonearm matching topic can be. Researching on-line will provide you with ...

    12. Aluminum vacuum platter for a Rockport System II Sirius turntable

      Hello, Up for sale is an aluminum vacuum platter for a Rockport System II Sirius belt drive turntable. Again, this is a vacuum platter, but it can also be used as a conventional non-vacuum platter. The perimeter seal is absent, but everything else is intact. Replacing the perimeter seal will restore vacuum operation. This is a very heavy 12 pound two-piece constrained layer damped high-end ...

    13. Koetsu Onyx moving coil phono cartridge

      Hello, Up for sale is a Koetsu Onyx low output voltage moving coil cartridge serial # 10029 fully tested and documented with micro photographs of the stylus condition. This features a genuine beautiful jeweled Onyx body, a stepped boron cantilever, and a semi line-contact stylus. These sold for $1,100 in 1981. Today’s Onyx model sells for about $10,000.00. Although what’s being sold here is ...

    14. Sony PS-X800 turntable supplemental counterweight kit

      Hello, Many Sony PS-X800 turntable owners have lost the original thin and thick supplemental tonearm counterweights and these parts are no longer available. This will be a problem for users that are attempting to use a cartridge/headshell combination that exceeds 17 grams total, as the PS-X800 tonearm will only auto zero balance cartridge/headshell combinations from 10 to 17 grams when not ...

    15. SPEKTURM DX6 TRANSMITTER

      DX6 TRANSMITTER W/AR610 RECEIVER, USED W/RC PLANES, HELICOPTERS, SAILPLANES. (EC) COST $229.

    16. Used RC Airplane

      Sportsman +s EC, flown 2 times, W/DX4e transmitter, Cost $350. $225 (OBO) tel: (352) 753-2945. Located it The Villages, FL

    17. Monster Power Conditioner Pro 600

      This is a 9 receptacle power conditioner that is in "Like New" condition. I bought it a while back(this is still in production) and never used it because someone else got one for me. It's been stored ever since.Asking $40. Feel free to call or text@ 352-255-6273 ask for Terry or Judy. thanx for looking..............Terry

    18. Lexmark printer/scanner

      In excellent working order. Comes with program CD. No ink cartridge included.

    19. Laptop external fan

      This is a external cooling fan for your laptop, it elevates your pc a couple of inches for better screen viewing, plugs into a USB port on any laptop, is quiet and works as new, is silver in color and looks nice. Your pc sits on top of the fan. Price is only 9.95 and you pay shipping, it is light weight. Thank you.